BBQ CyberQ Temperature Control Infrastructure Mode

Connecting to a Wi-Fi Network in Infrastructure Mode

To set up a link from scratch, proceed with the following steps:

  1. Power up the CyberQ and wait until the display shows Pairing in Hot-spot Mode. 

  2. Press and hold down the UP and DOWN arrows together to enter SYSTEM SETUP mode. 

  3. When >SYSTEM SETUP is displayed, push the RIGHT arrow to enter WIFI SETUP mode 

  4. Scroll down to >SCAN WI-FI and push the RIGHT arrow. 

  5. When you see Networks Found followed by as number, scroll to your Wi-Fi Network and then 
press the CENTER button. 

  6. Press the LEFT arrow to go back to WIFI SETUP. 

  7. Scroll down until you see SSID: (Your Network Name should be selected) 

  8. Continue to scroll down to KEY: then push the CENTER button. 

  9. Enter your Wi-Fi Network password using the directional arrows (UP for numbers and upper 
case, DOWN for lower case, RIGHT to move to the next character). Leave the cursor on the 
final character. 

  10. Press the CENTER button to save the password. 

  11. Unplug the unit and plug it back in. The display will show IP ADDRESS INFS 
  12. The unit should now connect to your network and will briefly display the CyberQ’s Network 
IP Address. 

  13. To find this IP Address again, press and hold down the UP and DOWN arrows together to 
enter SETUP mode. 

  14. When >SYTEM SETUP is displayed push the Right arrow.
  15. Scroll down to just below the >SCAN WI-FI and you will see the CyberQ’s Network IP 
Address. (This should look something like 192.168.1.XX or 10.0.0.XX) 

Enter this address into a web browser on a device that is connected to the same Wi-Fi network and you should see the CyberQ Temperature Controller status screen. Note that most browsers will automatically add http://www. to the address. You just need to enter the IP numbers without the www in the browser address window.