5-in-1 Magnetic Control Assembly

The DynaQ should be placed in a stable position in its stand. The control can be rotated to face any direction and can sit at any desired angle by tightening the mount knob. Its built-in magnet allows for versatile mounting. The control must be protected from the elements and special precaution must be taken to care for the control as with any other electronic device.

1. Attach the lower stand platform to the upper control bracket using the included hex bolt and thumb nut. 

2. From the underside of the lower stand platform, press the rubber feet into the holes to prevent the stand from sliding. 

3. Snap the control onto the upper control bracket facing any direction. 

4. Tilt the upper control bracket to the desired angle and tighten the thumb nut on the hex bolt to keep the bracket in the selected position.

                                   

MOUNTING TO THE MONOLITH GRILL 

Note: The additional bracket required to attach the control to the shelf is included only with the Monolith Grill. This assembly requires the hex bolt, thumb nut and upper control bracket from the 5-in-1 magnetic mount that was included with the control.  

1. Attach the sheet metal mount to the left side shelf by placing the Phillips-head screw through the existing hole on the bottom shelf rail and tighten the included nut to hold it in place. 

2. Use the hex bolt and thumb nut from the 5-in-1 magnetic mount to attach the upper control bracket to the sheet metal mount. 

3. Snap the control onto the upper control bracket with the Q-tail pointing down diagonally to the right. 

4. Tilt the upper control bracket to the desired angle and tighten the thumb nut on the hex bolt to keep the bracket in the selected position.