Switching Between Home and Away Configurations

Switching Between Home and Away Configurations

Once you have linked to your home wifi network and set up hot-spot pairing with a monitor device using the above instructions, those settings are saved as Home and Away respectively. You can switch between them, either by using the buttons on the unit itself:

  1. Plug in the CyberQ. Wait until the display shows Pairing in Hot-spot Mode or IP ADDRESS INFS CONNECTING.

  2. Press and hold down the UP and DOWN arrows together to enter SYSTEM SETUP mode.

  3. When >SYSTEM SETUP is displayed, push the RIGHT arrow to enter WIFI SETUP mode.

  4. Press the DOWN arrow twice to >EDIT: and push the CENTER button.

  5. Press the UP arrow until Home or Away is displayed as desired, then push the CENTER button.

  6. Press the DOWN arrow to >LOAD: and push the CENTER BUTTON.

  7. Press the UP arrow until Home or Away is displayed as desired, then push the CENTER button.

Unplug the CyberQ, then plug it in again. The controller will now start in the desired configuration. Alternatively, you can use the internal Wifi Setup page:

Click in the WiFi Settings box and select the configuration you want to use. Click on Submit Values, then power-cycle the CyberQ. It will then use the desired configuration.